Special products

Very good covering aluminum paint for heat loads up to 600 °C

• Contains NO silicone, biocides, lead, zinc, chromate, cobalt, MEKO/butanone oxime or other heavy metals
• For iron and steel substrates that are free from rust, scale and grease
• From approx. 400 °C, the binder evaporates and the aluminum pigments sinter with the iron substrate
• At temperatures up to 250 °C, we recommend the use of Brantho-Korrux 3 in 1 RAL 9006 as an alternative

For 3 in 1 color shades (for effect shades please use Branth’s Quick Hardener Concentrate)

.

The minimum temperature for using the hardeners is 15 °C. The use of hardeners is only recommended for use as a top coat (NOT for pure base coats).

The pot life (time of use after mixing) is approx. 8-12 hours

If a high surface hardness is required, we recommend “2-Kompo” or “2K-Anti-Graffic-Lack”. 3 in 1″ is air-drying and is normally applied without hardener.

For S-glaze, Robust lacquer and 3-in-1 effect shades. Also possible with crystal glaze, but not necessarily recommended.

• Add 5-10%.
• Increases the surface hardness.
• Store hardener in a dry place (sensitive to moisture)

.

Dry, grainy and lightweight material

• After mixing in, largely neutral in color

• Slip resistance DIN 51130: R11

  Stir into the paint before applying. Stir occasionally in between

  Prime beforehand WITHOUT granules.

  Apply with brush and roller. Spray application only with suitable equipment.

• Similar products = Brantho-Korrux “3 in 1” effect colors (RAL 9007, DB 601, DB 701, DB 702, DB703)

• Neutral color

• Maximum 15% addition.

• Up to 20% glossier.

• Not for effect colors (RAL 9006, RAL 9007, DB 601, DB 701, DB 702, DB703, BK 096, BK084 and old copper)

• Alternatively and more effectively is a 1:1 mixture with Branth’s “Robust-Lack”

For wood as a primer or open-pore top coat

.

• Saturates wood from the inside with resin and oil (penetrates deeply)

• Makes the wood waterproof (ATTENTION: therefore do not paint over with water-based paints!)

Ultra-High Solid protective lacquer (>85% solids)

• single-component, smooth surface finish
• for iron and steel, bright or hand derusted
• very high covering power and coverage
• good corrosion protection